Airbag control unit, seat occupancy detection: 10: 15 — — 16: PSM control unit, electric parking brake (EPB), PDCC: 5: 17: Xenon headlights, right: 25: 18 — — 19: Transmission control unit/ transmission prewiring: 5: 20: 2011-2012: Seat memory control unit, seat adjustment switch for right seat 2013-2017: Seat memory control unit, right
Next, I tilted the seat back all the way. A few clicks at the end and release then re-press the button a few more clicks, no beeps. 4). Then I did the same tilting the seat all the way forward. After this, the seat memory buttons DID not work for me but for the author it did as he said. (I did not do this for the seat height or seat bottom
Pricing When comparing the Audi A4 and the Audi Q3, it is important to look at price, fuel economy, and standard features. Starting with price, the Audi A4 is more expensive with a starting MSRP of $42,295 and the similarly equipped Audi Q3 starts at $38,195.
Re: Memory seats not working – 28-01-2012, 08:29 AM. Managed to get someone with VCDS to check the car. I think it was caused by the following code: 01331 - Door Control Module; Driver Side (J386): Supply Voltage Too Low. Same with the rear passanger door, same side as drivers door.
Disconnecting the battery will cancel the memorized positions. Make sure that the remotes are linked. Press and hold the lock and unlock button at the same time. The red LED on the remote will flash one time when the remote has been linked and will flash two times when the remote has been unlinked.
3. Plug in the Rear HVAC Control Module and Vent cables (Don't install them into the housing yet, Need to test and visually verify the flap motors are working normally) 4. Clear the Rear HVAC faults using Vag-Com. 5. Go to Basic Settings and perform flap motor end stop calibration. Watch the flaps open and close.
MmlBw. 272 415 794 954 633 533 193 593
audi seat memory not working
